Peavey PV 1015 D Manuel D'utilisation page 20

Remove the cap to the fuse enclosure (2a), using a flat-blade screwdriver tip inserted into the fuse cap slot. Push
the cap in and turn the cap counterclockwise and pull the cap out. The blown fuse should come out with the cap.
Remove the blown fuse and replace it with the proper type per instructions previously supplied. Then, once the
new fuse has been put in place, re-insert the fuse enclosure cap, push in and turn the cap clockwise, and make
sure it is fully seated. Before re-attaching the IEC power cord to the IEC socket, make sure the Power switch is in
the OFF position, so that intermittent contact of the IEC cord while it is being connected will not unduly stress the
amplifier or the fuse. Now re-attach the IEC power cord, and you can then use the Power switch to turn the unit on.
ON/OFF SWITCH
3
This rocker switch supplies AC power to the PV
SPEAKER OUT JACK
4
This jack allows a full-range passive (unpowered) speaker to be connected to the PV 1015D internal power amp,
as long as it has an impedance rating no lower than 8 ohms, and is of similar sensitivity as the PV 1015D speaker
system. Ideally, this speaker would be the passive model PV 1015, however, other 8-ohm passive full-range
speakers with a nominal sensitivity of around 95 dB can be used. This additional speaker system can help
increase coverage of the venue. The volume level of this added speaker is controlled at the same time as the
volume of the PV 1015D, thus the need to use a speaker system with a similar sensitivity.
It can also be used to drive an 8-ohm impedance, non-powered subwoofer with a built-in high-frequency roll-off,
such as the PV 118 Sub.
T O p p a n e l
INPUT JACK
5
The line-level input is of the medium impedance type. Jack (5) is a combination female XLR and 1/4" TRS
connector, and can be supplied with a balanced or unbalanced input signal.
LEVEL
6
Controls the gain (volume) of the Input (5) of the powered speaker system.
CONTOUR SWITCH
7
The Contour switch provides a mild boost at the frequency extremes, so that low-level playback can be more
pleasing. Do not use the Contour switch when playing sound at loud levels, as the boost is not needed then.
LINK OUT
8
Link Out is a 1/4" pre-level send intended for the use of linking multiple PV 1015D enclosures in a line. In that case,
the Link Out would connect to the 1/4" connections of the MIC/LINE (5) input of the next PV 1015D in the line of PV
speakers. Individual speakers can be adjusted by their own Level control (6). This output can also be used to drive
a nearby powered subwoofer, such as the PV 118D Sub. Set the PV 118D Sub level control to a level that matches
that of the output of the PV 1015D.
®
1015D when switched to the ON position.
5 6 7 8 9