Annovi Reverberi POWER GARDEN CAR 35 Notice D'utilisation Et D'entretien page 52

5.3 HANDWASH CAN
The POWER GARDEN CAR 75, CAR 90 and CAR 130 trolleys
EN
are fitted with a 5 litre handwash can (Figure D Pos.11).
Make sure the handwash can is full of clean water before
starting treatment. To fill it, turn its cover counterclockwise
(Figure D Pos.12). In case of need, lift the can by its handle
and place it in its holder on the outside of the main tank, so
that its tap is accessible for use (Figure D Pos.13).
5.4 PRELIMINARY CHECKS
1. Before starting the motor, check that the trolley is on a flat surface and cannot tip over.
2. Check the inflation of the pump pressure accumulator (as applicable) with a compressed air gun with pres-
sure gauge, like those used for checking car tyres. If it is deflated, restore the pressure per the following table.
WORKING PRESSURE
bar
2 - 5
5 - 10
10 - 20
20 - 40
3. Check that any taps (49) not connected to services, and mounted on the
pressure regulating valve (45) are perfectly closed.
4. Check that the selector lever (46) of the pressure regulating valve (45) is
set to the bypass setting.
5. Make sure that the lever (22) on the lance (7) is closed.
6. Check the electrical hookup, if using an electric pump (52).
52
psi
29 - 73
73 - 145
145 - 290
290 - 580
7
Annovi Reverberi S.p.A. Via Martin Luther King, 3 - 41122 Modena - Italy
12
11
ACCUMULATOR PRESSURE
bar
2
2 - 5
5 - 6
6
22
EN
13
D
psi
29
29 - 73
73 - 87
87
49
46