BorMann PRO BBP5150 036326 Mode D'emploi page 9

EN
Tool / battery protection system
The tool is equipped with a tool/battery protection system. This system automatically cuts off power to the motor to extend tool and battery life. The tool will
automatically stop during operation if the tool or battery is placed under one of the following conditions:
Overload protection : when the battery is operated in a manner that causes it to draw an abnormally high current, the tool automatically stops without any
indication. In this situation, turn the tool off and stop the application that caused the tool to become overloaded. Then turn the tool on to restart.
Overheat protection: when the tool or battery is overheated, the tool stops automatically. In this situation, let the tool/battery cool before turning the tool on
again.
Overdischarge protection: when the battery capacity becomes low, the tool stops automatically. If the product does not operate even when the switches are
operated, remove the batteries from the tool and charge the batteries.
Indicating the remaining battery capacity
1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indicate the remaining battery capacity. The indicator lamps light off immediately when release the check
button.
NOTE:
Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity.
Operation
WARNING:
1. Trigger
2. Lock button
9
Before ins talling the battery cartridge into the tool, always check to see that the trigger
actuates properly and returns to the "OFF" position when released.
WWW.NIKOLAOUTOOLS.GR
Charging status indicator lights
Lit
To start the tool, simply pull the trigger. Tool speed is increased by increasing pressure
on the trigger. Release the trigger to stop. For continuous operation, pull the trigger,
push in the lock button and then release the trigger. To stop the tool from the locked
position, pull the trigger fully, then release it.
Trigger can be locked in "ON" position for ease of operator comfort during
extended use. Apply caution when locking tool in "ON" position and maintain firm grasp
on tool.
NOTE: Even with the switch on and motor running, the drive bit does not rotate.
Push the tool forward to engage the clutch.
NOTE: The tool automatically stops if the motor keeps rotating for about 6 minutes.
Remaining
capacity
Off
GREEN
ORANGE 75% to 100%
RED
25% to 50%
ORANGE
RED
10% to 25%
RED