Publicité
Les langues disponibles
Les langues disponibles
EN
Lighting up the front lamp
Do not look in the light or see the source of light directly.
Pull the trigger to light up the lamp. The lamp keeps on lighting while the trigger is
being pulled. The lamp goes out immediately after releasing the trigger.
NOTE: Use a dry cloth to wipe the dirt off the lens of the lamp. Be careful not to scratch
the lens of lamp, or it may lower the illumination.
Selecting the direction of rotation
- Always check the direction of rotation before operation.
- Use the direction of rotation selection lever only after the tool comes to a
complete stop. Changing the direction of rotation before the tool stops may damage
the tool.
- When not operating the tool, always set the direction of rotation selection lever to
the neutral position.
This tool has a direction of rotation selection lever to change the direction of rotation.
Move the direction of rotation selection lever to the position (A side) for clockwise
rotation or to the position (B side) for counterclockwise rotation. When the direction of
rotation selector is in the neutral position, the trigger cannot be pulled.
Depth adjustment
The depth can be adjusted by turning the locator. Turn it in "B" direction for less depth and
in "A" direction for more depth. One full turn of the locator equals 2 mm (1/16") change
in depth.
Adjust the locator so that the distance between the tip of the locator and the screw head
is approximately 3 mm (1/8") as shown in the figures. Drive a trial screw into your material
or a piece of duplicate material. If the depth is still not suitable for the screw, continue
adjusting until you obtain the proper depth setting.
10
1. Lamp
1. Direction of rotation selection lever
WWW.NIKOLAOUTOOLS.GR
1. Locator
Publicité
