Publicité
Les langues disponibles
Les langues disponibles
EN
ASSEMBLY
Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool.
Installing or removing driver bit/socket bit
1. Locator
1. To remove the driver bit, pull the locator, and then grasp the bit with a pair of pliers and pull the bit out of the magnetic bit holder. To install the
driver bit, push it firmly into the magnetic bit holder. Then install the locator by pushing it firmly back.
2. To install the driver bit, follow the removal procedure in reverse.
Installing or uninstalling the hook
The hook is convenient for temporarily
hanging the tool. This can be installed on
either side of the tool. To install the hook,
insert it into a groove in the tool housing
on either side and then secure it with a
screw. To remove, loosen the screw and
then take it out.
11
2. Driver bit
3. Magnetic bit holder
W When installing the hook, always secure it with the screw firmly.
If not, the hook may come off from the tool and result in personal injury.
1. Groove
2. Hook
3. Screw
WWW.NIKOLAOUTOOLS.GR
Publicité
