Publicité
Les langues disponibles
Les langues disponibles
STEP 4 Initial settings
By completing the following steps, the refrigerator should be fully functioning.
1. Remove the PE foam sheet on each shelf corner, which is attached to protect the
refrigerator during transportation.
2. Plug the power cord into the wall socket to turn the refrigerator on.
3. Open the door, and check if the interior light lights up.
4. Set the temperature to the coldest, and wait for about an hour. The freezer will then
be slightly chilled, and the motor will run smoothly.
5. Wait until the refrigerator reaches the set temperature. Now the refrigerator is
ready for use.
STEP 5 Final check
When installation is complete, confirm that
• The refrigerator is plugged into an electrical outlet and grounded properly.
• The refrigerator is installed on a flat level surface with a reasonable clearance from
the wall or the cabinet.
• The refrigerator is level and is sitting firmly on the floor.
• The door opens and closes freely, and the interior light turns on automatically when
you open the door.
English 35
Publicité
