IKRA Mogatec IBKH 33 Manuel D'utilisation page 73

• Horizontal cut (with straight cutter bar)
Cutting without standing directly in front of the hedge
- large working radius
• Overhead cut (with angled cutter bar)
Hold the hedge cutter above your head and swing it in
an arc to make maximum use of its reach.
Any working position above head height is tiring. To
minimize the risk of accidents, work in such positions for
short periods only. Set angle of adjustable cutter bar to
maximum so that the unit can be held in a lower, less tir-
ing position (with harness) while still providing adequate
vertical reach.
• Horizontal cut (with angled cutter bar)
Cutting close to the ground from a standing position,
e.g. low shrubs
Do not throw cuttings in the rubbish bin (garbage
can) -they can be composted
7. BRUSHCUTTER & TRIMMER
Main Parts
1. Power Unit
2. Cutting device guard
3. Cutting device
a) Blade with 3 points
b) Cutting line head
4. Blade protection (for transport)
5. Angle transmission
GB-30