JVC I'Art AV-27F485 Mode D'emploi page 18

Les langues disponibles

Remote Programming

Setting the CATV, VCR and DVD Codes

You can program your remote to operate your cable box, satellite receiver, VCR or DVD

player by using the instructions and codes listed below. If the equipment does not respond to

any of the codes listed below or to the code search function, use the remote control supplied

by the manufacturer.

Cable Box or Satellite Codes

The remote control is programmed with cable box and satellite codes for power on/off,

channel up/down, and 10 key operation.

1) Find the cable box or satellite brand from the list of codes shown below.

2) Slide the 2-way selector switch to "CATV".

3) Press and hold down the D

key pad.

4) Release the D

ISPLAY

• If your cable or satellite box does not respond to the first code, try the others listed. If it does

not respond to any code, try the search codes function, on page 21.

��

button, then enter the first code number listed with the 10

ISPLAY

button, and confirm the operation of the cable box/satellite receiver.

��

I'art av-32f485 I'art av-27f475 I'art av-32f475 I'art av-36f475