Texas CG260BS Manuel D'utilisation page 36

Grass is wrapped around
the gear head or line
head.
The spool head is difficult
to turn.
Oil leaks from the
exhaust
14. Specifications
TYPE
Transmission
Reduction rate.
Handle
Net weight (kg)
Engine name
Carburetor
Displacement Volume cc
Ignition
Starter
Fuel
Trimmerline (size)
TYPE
Connection
Reduction ability
Handle
Dry weight (kg)
Engine name
Carburettor
Displacement Volume cc
Ignition
Start
Fuel
Tank capacity (L)
Trimmerline (size)
3. The line is worn short.
4. The line is entangled.
5. The rotations of the
engine are too slow.
1. Tall grass is cut at base.
2. The trimmer is not used at
full speed.
The threads are dirty,
damaged or full of grass.
1. The trimmer is not used
on full power.
2. Check the mix of the fuel.
3. The air filter is dirty.
4. The carburetor needs
adjustment.
www.texas.dk
Pull out more line while alternately pressing the
line head down and letting go.
Remove the line from the spool and fit it again.
Pull out more line at full speed.
Cut the grass from the top and downwards.
Use the trimmer at full speed.
Clean the threads and grease or change the spool
head. Remove any grass..
Use full power
Use new fuel and correct two-stroke mix.
Clean or replace.
Contact your local dealer.
CG 230 B
Automatic centrifugal clutch
V-handle
5,4 kg
1E31F
Diaphragm type
22,6 cc
Non-contact – electronic ignition
Recoil
Unleaded gasoline mixed with two-stroke oil.
2,4 mm
CG 260 B / CG260 BS
Automatic centrifugal clutch
17:22
V-handle
6,2 kg
1E34F
Diaphragm type
26 cc
No switch – electric ignition
Recoil
Unleaded octane 95, mixed with 2-stroke oil.
0,72
2,4 mm
7:9
36