Publicité
Les langues disponibles
Les langues disponibles
WARNING:
area. Carbon monoxide exhaust fumes can be lethal in
a confined area.
WARNING:
starting position when pulling the starter rope (Fig. 8).
To avoid serious injury, the operator and unit must be
in a stable position while starting.
Make sure that any Add-On item is installed correctly
and secure before starting the unit.
STARTING INSTRUCTIONS
1. Mix gas with oil. Fill fuel tank with fuel/oil mixture.
See Oil and Fuel Mixing Instructions.
2. Make sure the On/Off Stop Control in the ON ( I )
position (Fig. 6).
3. Fully press and release the primer bulb 10 times,
slowly. Some amount of fuel should be visible in the
primer bulb and fuel lines (Fig. 7). If you can't see
fuel in the bulb, press and release the bulb as many
times as it takes before you can see fuel in it.
4. Push the blue EZ-Start™ lever towards the primer
bulb until it clicks and locks into place (Fig. 7).
5. Crouch in the starting position and do not squeeze
the throttle control (Fig. 8). Pull the starter rope out
with a controlled and steady motion until the engine
attempts to start. Repeat until the engine starts.
NOTE: The unit uses EZ-Pull Version 3™, which
significantly reduces the effort required to start the
engine. You must pull the starter rope out far
enough to hear the engine attempt to start. There
is no need to pull the rope briskly-- there is no
harsh resistance when pulling. Be aware that this
starting method is vastly different from (and much
easier than) what you may be used to.
6. When the engine starts, squeeze the throttle control
for 15 to 30 seconds. This will warm up the unit. The
blue EZ-Start™ lever will click off automatically
when you squeeze the throttle control.
IF...
The engine does not start, go back to step 3.
IF...
The engine stops while you are squeezing the
throttle, go back to step 4.
IF...
The engine stops before you squeeze the throttle
control, hold the throttle control and pull the starter
rope until the trimmer starts.
NOTE: If you are having trouble starting the unit or are
operating in extreme temperatures (below 40º F,
above 90º F), refer to the Troubleshooting section.
STOPPING INSTRUCTIONS
1. Release your hand from the throttle control. Allow the engine
to cool down by idling.
2. Put the On/Off Stop Control in the OFF (O) position (Fig. 6).
STARTING/STOPPING INSTRUCTIONS
Operate this unit only in a
well- ventilated outdoor
Avoid accidental starting.
Make sure you are in the
Fig. 6
Primer
Bulb
Fig. 7
Starting Position
Trimmer
Equipped With
EZ-Pull
Version 3 ™
Throttle Control
Fig. 8
Stop/Off (O)
Start/On (I)
Blue EZ-Start™
Lever
9
Publicité
