Télécharger Imprimer la page

Blackstar Amplification HT-1 Mode D'emploi page 3

Publicité

Warning!
Important safety information!
READ
THE
FOLLOWING
INSTRUCTIONS FOR FUTURE REFERENCE!
Follow all warnings and instructions marked on the product!
Danger! High internal operating voltages.
Do not open the equipment case. There are no user serviceable parts in this
equipment. Refer all servicing to qualified service personnel.
Clean only with a dry cloth.
Condensation can form on the inside of an amplifier if it is moved from a cold
environment to a warmer location. Before switching the unit on, it is recommended
that the unit be allowed to reach room temperature.
Unauthorised modification of this equipment is expressly forbidden by Blackstar
Amplification Ltd.
Never push objects of any kind into ventilation slots on the equipment casing.
Do not expose this apparatus to rain, liquids or moisture of any type.
Do not place this product on an unstable trolley, stand or table. The product may
fall, causing serious damage to the product or to persons!
Do not cover or block ventilation slots or openings. This unit must only be used in
a well ventilated area and never switched on when it is within a poorly ventilated
space, such as a bookcase.
This product should not be placed near a source of heat such as a stove, radiator,
or another heat producing amplifier.
Use only the supplied power cord which is compatible with the mains voltage
supply in your area.
Power supply cords should always be handled carefully and should be replaced
if damaged in any way.
Never break off the earth (ground) pin on the power supply cord.
The power supply cord should be unplugged when the unit is to be unused for
long periods of time.
An apparatus with Class 1 construction should be connected to a mains socket
outlet with a protective earthing connection.
The mains plug of the power supply cord should remain readily accessible.
Before the unit is switched on, the loudspeaker should be connected as described
in the handbook using the lead recommended by the manufacturer.
Always replace damaged fuses with the correct rating and type.
Never disconnect the protective mains earth connection.
4
INFORMATION
CAREFULLY.
SAVE
High loudspeaker levels can cause permanent hearing damage. You should
therefore avoid the direct vicinity of loudspeakers operating at high levels. Wear
hearing protection if continuously exposed to high levels.
ALL
If the product does not operate normally when the operating instructions are
followed, then refer the product to a qualified service engineer.
Minimum distances 5 mm around the apparatus for sufficient ventilation.
No naked flame sources, such as lighted candles, should be placed on the
apparatus.
The use of apparatus in moderate climates.
The MAINS plug is used as the disconnect device, the disconnect device shall
remain readily operable.
The U.S. Government´s Occupational Safety and Health Administration (OSHA)
has specified the following permissible noise level exposures:
Duration Per Day In Hours
8
6
4
3
2
1
½
¼ or less
According to OSHA, any exposure in excess of the above permissible limits could
result in some hearing loss.
Ear plug protectors in the ear canals or over the ears must be worn when
operating this amplification system in order to prevent a permanent hearing loss if
exposure is in excess of the limits as set forth above. To ensure against potentially
dangerous exposure to high sound pressure levels, it is recommended that all
persons exposed to equipment capable of producing high sound pressure levels
such as this amplification system be protected by hearing protectors while this
unit is in operation.
All electrical and electronic products should be disposed of separately
from the municipal waste stream via designated collection facilities
appointed by the government or the local authorities.
Sound Level dBA, Slow Response
90
92
95
97
100
102
105
110
115
5

Publicité

loading

Ce manuel est également adapté pour:

Ht-1rh18883