Makita DC40WA Manuel D'instructions page 6

Voltage
40 V (max.)
40 V (max.)
40 V (max.)
40 V (max.)
40 V (max.)
NOTICE:
The battery charger is for charging Makita-battery cartridge. Never use it for other purposes or
for other manufacturer's batteries.
NOTE: If the charging light flashes slowly in blue color, charging may not start due to the condition of the battery
cartridge as below:
— Battery cartridge from just-operated tool or battery cartridge that has been left in a location exposed to direct
sunlight for a long time.
— Battery cartridge that has been left for a long time in a location exposed to cold air.
NOTE: When the battery cartridge is too hot, charging does not begin until the battery cartridge temperature
reaches the degree at which charging is possible.
NOTE: If the charging light changes to red color, charging is not possible. The terminals on the charger or battery
cartridge are clogged with dust or the battery cartridge is worn out or damaged.
Wall mounting
WARNING:
Make sure to use two screws for hanging the charger on the wall, and anchor the charger
on the wall with another screw. Otherwise the charger may fall and cause serious injury.
WARNING:
Always be sure that the charger is unplugged and all the batteries are removed from the
charger before performing wall mounting work.
WARNING:
Follow the steps instructed in this manual, and complete the whole procedures at once.
The charger may fall and cause injury or damage if you stop the work in the half way.
WARNING:
Check tightness of the screws on regular basis. Otherwise the charger may fall because of
loosen screw.
WARNING:
Clean the terminal parts of the charger on regular basis with an air duster etc.
CAUTION:
Carefully choose a stable wall for mounting the charger. Make sure there is no hindrance
to mounting work or charging operation. The gross weight of the charger and battery reach approximately
5.0 kg (11 lbs). Provide sufficient reinforcement for the wall if necessary.
CAUTION:
Be careful not to drop the battery cartridge when inserting or removing the battery from the
wall-mounted charger. Hold the battery cartridge firmly and keep a stable posture.
You can mount the charger on the wall. Make a clearance around the charger as shown in the figure.
► Fig.3
NOTE: Things you need to prepare:
— Two screws - hanging the charger
Screw size : 4.0 mm x equal to or more than 20 mm.
Screw head size : Less than ø9.0 mm and less than 3.5 mm thickness.
— One screw (4.0 mm x equal to or more than 25 mm) - for anchoring the charger.
— Tools - for tightening screws
1. Fix two screws for hanging on the wall.
2. Hang the charger on the wall using the hook on the back.
► Fig.4
3.
Fix the charger by tightening an anchor screw at the top of the charger.
► Fig.5
Number of cells Li-ion battery cartridge
10
10
10
20
20
Capacity (Ah)
BL4020
BL4025
BL4040
BL4050F
BL4080F
6 ENGLISH
Charging time
(Minutes)
2 110
2.5 130
4 210
5 260
8 420