All manuals and user guides at all-guides.com
40000400 English.qxd
26/08/2003
What might be the cause of...
Defects you can remedy yourself
Before calling Service for technical advice please run through the following
checklist. A charge will be made if the machine is found to be working or has been
installed incorrectly or used incorrectly. If the problem persists after completing the
recommended checks, please call Service, they may be able to assist you over
the telephone.
PROBLEM
1. Does not work on any programme
2. Does not fill with water
3. Water does not drain away
4. Water on floor around the washing
machine
5. Does not spin
6. Machine vibrates a lot during spin
7. Door will not open
8. The control knob turns a full circle
quickly during a programme.
13:15
Page 28
Trouble shooting
CAUSE
Plug not in socket.
Not switched on.
Power failure.
Fuse blown.
Door open.
RCD tripped (trip switch)
See cause 1.
Water supply turned off.
Programme selector not correctly
positioned.
Kink in discharge hose.
Foreign bodies in filter
The machine has been plumbed in
incorrectly.
Leaking gasket between tap and
water inlet hose.
Strand of clothing or dirt between
door rubber gasket and door glass.
Incorrect plumbing.
Water has not yet drained away.
'Spin Cancel' option selected
(certain models only).
Unbalanced load.
Washing machine not completely level.
Load not distributed evenly.
Transit brackets not removed.
Two minutes have not elapsed since
the programme finished.
The control knob was not at the
expected position when automatically
checked by the machine.
28
REMEDY
Plug it in.
Switch on.
Check and refer to 'Power Failure'
section.
Check.
Close door.
Reset RCD.
Check.
Turn on water supply.
Position programme selector
correctly.
Straighten discharge hose.
Examine filter.
Check installation.
Replace gasket and tighten
connection.
Re-load the machine and keep
rubber door gasket/door glass clean.
Check plumbing.
Wait a few minutes for machine to
empty.
Check.
Rearrange load evenly.
Adjust the special adjustable feet.
Rearrange the laundry evenly.
Remove transit brackets.
Wait two minutes.
None.
This action is normal if the knob has
been moved accidentally during a
cycle.