All manuals and user guides at all-guides.com
40000400 English.qxd
26/08/2003
Testing the installation
Refer to the programme guide for details of how to select programmes.
1. Turn on the water supply and check for leaks from fill hoses.
2. Switch on the electricity supply.
3. Select a spin programme and then press the START/PAUSE button to start
the machine.
Allow the programme to continue for one minute and then cancel the
programme (please refer to "Description of Controls" section for cancelling the
programme). This will remove any water remaining in the machine from factory
testing.
4. To check for cold water filling to the machine:
Select a rinse programme and press the START/PAUSE button to start the
machine.
Allow the tumble action to continue until the water has pumped out.
Check that the drain outlet is not leaking or overflowing.
5. Switch off the machine at the end of the cycle by turning the programme knob
to the "OFF" position.
6. To check for hot water filling to the machine:
Select programme 1 and press the START/PAUSE button to start the
machine.
Allow the wash action to continue for one minute, then cancel the programme.
Alternatively, both inlets can be connected to the cold water supply by using a
suitable adaptor.
7. Select a spin programme and press the START/PAUSE button to switch the
machine on. If the machine takes longer than one minute to empty check the
drain hoses for kinks.
Installation testing is now complete.
13:15
Page 10
10