Marquant MCR-1295 Mode D'emploi page 8

INSTALLATION
Sleeve
L Key
Outer Trim Ring
Front Panel
6. Mount the sleeve by inserting the sleeve into the
opening of the dashboard and bend open the
tabs located around
screwdriver. Not all tabs will be able to make
contact, so examine which ones will be most
effective. Bending open the appropriate tabs
behind the dashboard to secure the sleeve in
place.
Screwdriver
7. Reconnect the wire harness and the antenna
and be careful not to pinch any wires or cables.
8. Slide the unit into the sleeve until it locks into
place.
9. To further secure the unit, use the supplied
metal strap to secure the back of the unit in
place. Use the supplied hardware (Hex Nut
(M5mm) and Spring Washer) to attach one end
of the strap to the mounting bolt on the back of
the unit. If necessary, bend the metal strap to fit
your vehicle's mounting area. Then use the
supplied hardware (Tapping Screw
R Key
the sleeve with
Dashboard
Tabs
Sleeve
and Plain Washer) to attach the other end of
metal strap to a solid metal part of the vehicle
under the dashboard. This strap also helps
ensure proper electrical grounding of the unit.
Note to install the short threading terminal of the
mounting bolt to the back of the unit and the
other long threading terminal to the dashboard.
Mounting Bolt
a
10. Reconnect the cable to the vehicle battery's
negative (-) terminal. Then replace the outer trim
ring and install the unit's front panel (see the
steps of "installing the front panel").
Removing the unit
1. Make sure the ignition is turned off, then
disconnect the cable from the vehicle battery's
negative (-) terminal.
2. Remove the metal strap attached the back of the
unit (if attached).
3. Press the release button to remove the front
panel.
Lift the top of the outer trim ring then pull it out to
remove it.
4. Insert both of the supplied keys into the slots at
the middle left and right sides of the unit, then pull
the unit out of the dashboard.
8
Hex Nut
Spring Washer
Metal Strap
Plain Washer
Tapping Screw