Marquant MCR-1295 Mode D'emploi page 27

MENU OPERATION
3) AUDIO SETUP
When you open the AUDIO menu, you will see the following picture:
* AUDIO OUT: Change among SPDIF/OFF, SPDIF/RAW and SPDIF/PCM.
* KEY: Change the tone within a certain range.
4) VIDEO SETUP
When you open the VIDEO menu, you will see the following picture:
You can adjust the value of the brightness, contrast, hue, saturation and sharpness.
5) DIGITAL SETUP
When you open the DIGITAL menu, you will see the following picture:
* OP MODE: to set the operating modes for Dolby Digital decoder, there are LINE OUT and RF REMOD
to be selected.
* DYNAMIC RANGE: you can adjust the dynamic range between 1/8, 2/8. 3/8, 1/2, 5/8, 3/4, full.
* DUAL MONO: there are STEREO, MONO L, MONO R and MIX MONO to be selected.
※ LAST PLAY MEMORY
1) During disc playback, if you turn off the unit and then turn on the unit again, the DVD unit will resume
playing from the point that just interrupted.
2) During disc playback, if you press MODE button to switch to other mode, then return to DVD mode
again, the unit will resume playing from the point that just interrupted.
AUDIO SETUP
AUDIO OUT
KEY
EXIT SETUP
VIDEO SETUP
BRIGHTNESS
CONTRAST
HUE
SATURATION
SHARPNESS
EXIT SETUP
DIGITAL SETUP
OP MODE
DYNAMIC RANGE
DUAL MONO
EXIT SETUP
27