Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Notes:
Choose the mounting location where the unit
will not interfere with the normal driving function
of the driver.
Before finally installing the unit, connect the
wiring temporarily and make sure it is all
connected up properly and the unit and the
system work properly.
Use only the parts included with the unit to
ensure
proper
unauthorized parts can cause malfunctions.
Consult with your nearest dealer if installation
requires
the
drilling
modifications of the vehicle.
Install the unit where it does not get in the
driver's way and cannot injure the passenger if
there is a sudden stop, like an emergency stop.
If installation angel exceeds 30° from horizontal,
the
unit
might
performance.
Avoid installing the unit where it would be
subject to high temperature, such as from direct
sunlight, or from hot air, from the heater, or
where it would be subject to dust, dirt or
excessive vibration.
DIN FRONT/REAR-MOUNT
This unit can be properly installed either from "Front"
(conventional DIN Front-mount) or "Rear" (DIN
Rear-mount installation, utilizing threaded screw
holes at the sides of the unit chassis). For details,
refer to the following illustrated installation methods.
TAKE OUT SCREW BEFORE
INSTALLATION
Before install the unit, please remove the two
screws.
installation.
The
use
of
holes
or
not
give
its
optimum
30
DIN FRONT-MOUNT (Method A)
of
Installation Opening
This unit can be installed in any dashboard having
other
an opening as shown below:
Installing the unit
Be sure you test all connections first, and then
follow these steps to install the unit.
1. Make sure the ignition is turned off, and then
disconnect the cable from the vehicle battery's
negative (-) terminal.
2. Disconnect the wire harness and the antenna.
3. Press the release button on the front panel and
remove the control panel (see the steps of
"removing the front panel").
4. Lift the top of the outer trim ring then pull it out to
remove it.
5. The two supplied keys release tabs inside the
unit's sleeve so you can remove it. Insert the
keys as far as they will go (with the notches
facing up) into the appropriate slots at the
middle left and right sides of the unit. Then slide
the sleeve off the back of the unit.
7
Take out screw
before installation.
Publicité
