Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Contents of Carton
1 - Air Compressor
2 - Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
2 - Molded Foot Bumpers
1 - Handle
1 - Handle Grip
2 - Screws, #10-16 x 1
Tools Required for
Assembly
1 - 9/16" socket or open end
wrench
1 - 3/8" socket
Installing Handles,
Wheels, and Molded Foot
Bumpers
The wheels
and handle do
not provide adequate clearance,
stability or support for pulling the
unit up and down stairs or steps.
The unit must be lifted, or pushed
up a ramp.
1.
Submerge handle grip into warm
soapy water to make installation
easier. Remove handle grip from
soapy water and slide onto
handle.
2.
Slide handle through holes in
compressor saddle onto tabs.
Secure with screws, one on each
side.
Compressor Saddle
Handle
Tab
A14083
ASSEMBLY
one side of the outfit when
installing the wheels because the
compressor will have a tendency to
tip over.
3.
4.
Screw
10- ENG
It will be necessary
to brace or support
Install one shoulder bolt and
one nut for each wheel. Tighten
securely. The outfit will sit level if
the wheels are properly installed.
Clean and dry underside of
Wheel
Nut
Shoulder Bolt
air tank leg opposite wheels.
Remove the protective strip from
the adhesive backed molded
foot bumpers. Attach the foot
bumpers to the bottom of leg
on each end. Press firmly into
place.
Molded Foot Bumpers
Publicité
