Wolf Garten UV 28 EV Mode D'emploi page 13

ssembly
ssembling bottom handle part (fig. M1)
Insert securing screw ( ) from inside through the left side
element, so that both projections catch in the recesses (1).
Position insulation element (B) from outside; the two nubs
must catch in the holes of the side element (2). Position
handle element (M) in the insulating element (B). Place
insulating element (C) so that the large opening points to
the outside. Then press washer (D) into the opening of the
insulating element (C) and tighten wing nut (G).
ssemble the right handle element in the same order.
ssembling top of handle (fig. M2)
Operation
Operating times
Please check noise abatement regulations prevailing in your
country.
Inserting power cable into cable holder (fig. )
Insert the power cord into the strain relief as shown in the
illustration.
Connection to the power outlet
(230 Volt C, 50 Hz). The machine can be connected to
any power outlet that is protected by a 16 amp fuse (or line
protecting switch type B).
Note:
Use a residual current protection device with a residual
current of no more than 30 m .
Setting the working depth (fig. B)
The working depth is adjustable to 3 heights (3 mm, -3 mm, -9
mm). Pull adjustment arm (1) away from side cover and allow
to catch in desired position (2). djust the height alternately
left and right by only 1 position. The adjustment arms must
always be in the same height position.
Maintenance
Disconnect from power supply before performing
maintenance and cleaning.
Clean the machine without water after each use (E).
Please note: the air intake slots of the electric motor must
be freed from grass and moss accumulations (B, 3)!
Do not spray machine with water. Store machine in a
dry room.
All manuals and user guides at all-guides.com
ttaching switch, strain relief and clips (fig. M3)
Fold up switch bracket (1) and position switch (H) on the
upper handle element so that the two nubs catch in the holes
(2). Close switch bracket (1) and insert cable strain relief (I).
Then fasten switch (H) and cable strain relief (I) with the two
screws (K). Fasten switch cable (3) with the clips (L) on the
handle rod.
ttaching protective flap (fig. M4)
Place protective flap (O) on the cover (1). Then press retainer
slots (2) into the fastening flaps (3) on the cover (1).
Recommended working depths
Lawn condition
Transport / uneven lawn surface
3 mm
Clean lawn surface
-3 mm
Worn blade
-9 mm
Starting up the engine/Scarifying (Fig. C)
1. Depress button (1) and hold.
2. Lift up bar (2) and release button (1).
3. Switch-off motor: Release bar (2).
Important: Place the cable firmly off the lawn or on the
already cut side of the lawn when starting to mow.
ttaching catch bag* (fig. D)
Lift protective flap (1). Hang catch bag (2) with the hooks on
both bolts** of the side elements.
(* TK 33 3615 060, accessory at additional cost, ** bolts
included with catch bag)
We recommend
llow a WOLF-service centre to check the unit in the
autumn.
Working position
13