Publicité
Les langues disponibles
Les langues disponibles
EN
FilterCart W3
Change the filter cartridge in the following way:
1.
Disconnect the mains connection cable.
2.
Unlock the eccentric locks and remove the filter casing.
3.
Use the plastic bag which comes with the new filter cartridge and pull it
over the used cartridge. Fold the plastic bag under the cartridge.
4.
Use a duster to wipe off the filter cartridge contact surfaces in the
FilterCart W3. Put the duster in the plastic bag with the filter cartridge
and close the bag with the band supplied.
5.
Handle the used filter cartridge according to the relevant regulations for
the substances that have been collected.
6.
Check that the pressure drop hose (from the control board) not is
damaged and is fitted properly.
7.
Check that the new filter cartridge is not damaged. Also check that the
seal fitted on the underside of the cartridge is not damaged. Then fit the
cartridge on the FilterCart W3.
8.
Refit the filter casing. Make sure the eccentric locks tighten the filter
casing properly.
10
Changing the HEPA filter (accessory)
See Figure 8. If the FilterCart W3 has been supplied with a HEPA filter, this is to
be changed at the same time as the main filter cartridge is changed.
WARNING!
Use necessary personal safety equipment when changing the HEPA filter.
Change the HEPA filter cartridge in the following way:
1.
Disconnect the mains connection cable.
2.
Unscrew the top cover.
3.
Remove the used HEPA filter and put it in the plastic bag which comes
with the new HEPA filter. Close the plastic bag with the band supplied.
4.
Handle the used HEPA filter according to the relevant regulations for the
substances that have been collected.
5.
Check that the new HEPA filter not is damaged. Note that the filter
surface must not be touched. Handle the HEPA filter very carefully and fit
it in the FilterCart W3. Ensure it is fitted in the correct position and that
the seal is downwards. Check that the seal not is damaged. Note the UP-
arrows.
6.
Refit the top cover. Fasten it securaly.
11
Maintenance
See Figure 9. Maintenance is recommended at least once a year.
16
All manuals and user guides at all-guides.com
A. Increasing the locking power.
B. Decreasing the locking power.
Risk of personal injury.
Publicité
