Publicité
Les langues disponibles
Les langues disponibles
OPERATION
• Press the push-button starter firmly to open the valve.
• Automatic shut-off after ~30 seconds (+5/-10 according to the European standard EN 816).
INSTALLATION
• The nozzle is interchangeable with an alternative nozzle (ref. DP) which enables a comfort rain-effect
spray to be obtained.
• When the push-button starter is released, a trickle of water will exit below the push-button.
This primes the hydraulic timing and activates the shower valve at the same time. Once the push-button
is released, the trickle of water will stop.
• Pressure: 1 - 5 bar (100 - 500kPa), we recommend 3 bar (300kPa).
Maximum pressure differential at the inlets: 1 bar.
• Tap: supply with cold or mixed water.
THE INSTALLER MUST:
• ENSURE THAT THE CONNECTION BETWEEN PANEL AND THE WATER INLET IS WATERPROOF
ON THE RECESSED INLET VERSION;
• CHECK THE INTEGRITY OF THIS CONNECTION AT LEAST ONCE A YEAR AND AS OFTEN AS
NECESSARY.
If this advice is not followed, water may leak into the wall.
DELABIE cannot be held responsible for any ingress.
FOR FURTHER INFORMATION PLEASE CALL DELABIE TECHNICAL SUPPORT
UK: 01491 821821. ALL OTHER MARKETS: +33 (0)3 22 60 22 74.
REMEMBER
• Our valves must be installed by professional installers in accordance with current regulations
and recommendations in your country, and the specifications of the fluid engineer.
• Sizing the pipes correctly will avoid problems of flow rate, pressure loss and water hammer
(see calculation table in our brochure and online at www.delabie.com).
• Protect the installation with filters, water hammer absorbers and pressure reducers to reduce
the frequency of maintenance (recommended pressure from 1 to 5 bar maximum).
• Install stopcocks close to the tap to facilitate maintenance.
• The pipework, filters, non-return valves, stopcocks, bib taps, cartridge and all sanitary fittings should
be checked at least once a year, and more frequently if necessary.
13
EN
Publicité
