Orbea OQUO Manuel De L'utilisateur page 15

28 | ORBEA
03 Insert the bead on the other side of
the tire into the rim around its entire
circumference. Start from the side of the
valve and from that point install the tire on
both sides of the circumference. As you
approach the opposite side from where
you started, it will become more difficult to
insert the bead into the rim. Hold the part
of the tire on both sides of the rim and
push the tire into the area not yet installed
so that the excess will allow you to fully
install the tire.
When installing the tire, make sure that the
tube is not pinched between the tire and
the rim.
USER MANUAL
04 Always inflate the tire within the tire
manufacturer's recommended pressures
and never exceed the maximum pressure
for a given tire and rim combination. Refer
to the table of maximum pressures in this
manual.
The tire should be properly set around
the entire rim. Note the line parallel to the
bead on the outside of the tire. The line
should be visible above the rim all the way
around the rim.
If you have trouble, you can use water with
a small amount of soap to lubricate the tire
bead.
Fit the valve nut.
OQUO WHEELS
CASSETTE INSTALLATION
When installing a cassette, check that it uses
the same mounting standard as the freewheel
hub on your rear wheel (Shimano HG, Shimano
Microspline, Sram XD/XDR...).
* Check the cassette fixing nut tightening
torque and the appropriate installation tool in
the cassette manufacturer's documentation.
40 N.m*
ORBEA | 29
EN