Rowenta Ultra Steam DR50 Serie Mode D'emploi page 8

1103901089 Index01 DR5000_105x148,5 21/01/10 10:54 Page8
All manuals and user guides at all-guides.com
IS THERE
Problems
There is no steam.
The appliance does
not heat.
Water leaks or spits.
There is not enough
power or too much.
For any product problems or queries, please visit our website -
www.rowenta.co.uk
or contact our Helpline on 0845 602 1454 - UK (01) 461 0390 - Ireland
Environment protection first !
Your appliance contains valuable materials
which can be recovered or recycled.
‹
Leave it at a civic waste disposal centre.
PROBLEM ?
Possible
causes
The steamer is not
plugged in.
The water level is too
low.
The steam button
has not been primed.
You use the
appliance for the first
time.
The water tank is not
in place.
It is not plugged in.
The water tank is not
in place.
Your appliance is not
hot enough.
The dual voltage is
not set correctly
The dual voltage is
not set correctly.
Solutions
Check that your appliance is
correctly plugged in.
Unplug your appliance and refill it.
Press the steam button
continuously for a few seconds to
begin steaming.
When the appliance is new, press
the steam button a few times.
Ensure that the water tank snaps
in when put into place.
Plug in your appliance.
Be sure that the water tank snaps
when put into place.
llow your steam brush to heat
for approximately 30 seconds
before using.
Ensure that the dual voltage
selector is in correct voltage
position before operating. Unplug
the appliance and switch the
selector to the correct voltage.
Ensure that the dual voltage
selector is in correct voltage
position before operating. Unplug
the appliance and switch the
selector to the correct voltage.
GB
8