Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT SAFETY INSTRUCTIONS REGARDING THE PLUG ON YOUR PRODUCT
ELECTRICAL RATINGS
This product is rated 12.5 Amps
(1500 Watts) at 120 VAC, 60 Hz except
for the HZ-605C which is 8.33 Amps
(1000 Watts) at 120 VAC, 60Hz.
SET-UP WHEEL BASE ASSEMBLY
NOTE: DO NOT OPERATE THE HEATER WITHOUT THE WHEEL BASE
ASSEMBLIES IN PLACE. THE HEATER MUST ALWAYS BE USED IN AN
UPRIGHT POSITION. DO NOT OPERATE THE HEATER IF THE WHEELS
ARE NOT ASSEMBLED CORRECTLY.
• Make sure the heater is unplugged and in the OFF position.
• Turn the heater upside down to install wheels.
• Push wheels into each wheel base pin, until you hear them snap into
position.
• While the heater is still upside-down, position the wheel base assemblies
between the end fins. Attach them to the U-bolts on the heater and
tighten using the wing nuts provided (Fig. 2).
• Turn heater right-side up. Your heater is now ready for use.
• Place the heater on a firm, level surface free from obstructions, and at
least 3ft. (0.9m) away from any wall or combustible material.
If the controls are located at the bottom and the Honeywell logo
is upside down you have installed the wheels incorrectly (Fig. 3).
NOTE: These heaters contain oil that is permanently sealed and will
never require refilling or replacing.
NOTE: THESE MODELS MAY TAKE UP TO SEVERAL MINUTES TO REACH
NORMAL OPERATIONAL TEMPERATURE.
All manuals and user guides at all-guides.com
Fig. 1
PRODUCT SPECIFICATIONS
Models
HZ-709/HZ-710 Series,
HZ-680/HZ-690 Series
Amps
12.5
Unit Voltage
120V, 60Hz
Max Watts
1500
Max BTUs
5118
Unit dims
13.6" L x 9.5" W x 25.2" H (assembled) 10"L x 9.5"W x 25.2"H (assembled)
HZ-605C Series,
8.33
120V, 60Hz
1000
3412
Fig. 2
(Bottom of Unit)
Wheel Base Pin
Wheel Base
U-bolts
Correct
Fig. 3
Wing Nuts
Incorrect
3
Publicité
