Publicité
Les langues disponibles
Les langues disponibles
Fitting the appliance into framing
Recess the appliance in the framing in accordance with
the wall finish details as shown below.
Install appliance PROTRUDING from Framing.
cement board
Using:
1365—4-Sided Surround, or
1370—Glass Surround Black:
• sheet metal front face of the appliance protrudes
in front of the framing studs by 1/2" (13 mm) plus
thickness of any non-combustible material over
top, such as tiles.
• cement board side pieces are not required for this
option. Top cement board piece may be cut as
necessary to span from top surface of appliance
to the header above. A steel stud (not supplied)
may be added to support the lower edge of the
board if necessary.
• drywall install up to sides of appliance.
cement board
steel stud
• surround can be installed flat against or floating
from the finished wall surface.
All manuals and user guides at all-guides.com
Appliance Preparation
Fixing the appliance to the framing
1. Remove the front bottom overlay panel by removing
2. Screw the appliance to the floor or wood surface
1/2" (13 mm) cement
board + thickness of
3. Screw the appliance to the side studs from the
non-combustible tile,
etc. (if used)
Note: It may
be necessary
to relocate
the stand-
offs further
back by
drilling your
4. Appliance fitted with the 1370 Glass Surround Black
own holes.
2 screws on each side and slide the panel out from
under the firebox.
with 4 countersunk wood or cement screws (not
provided).
inside of the appliance case behind the side
doors—1 screw each side.
NOTE: You will have to drill your own holes for these
fasteners.
NOTE: Fasteners may be adjusted later after the
wall finish is completed and the trim or surround (if
any) is applied.
or the 1365 Four-Sided Surrounds do not require
the black overlay. Discard or recycle the overlay.
3
Publicité
