Astralpool APH3 INVERBOOST 14 Manuel D'installation Et D'utilisation page 38

7.6.2 Press 5S and then press
Code Name
P0 Mandatory defrosting
P1 Working mode
P2 Timer on/off
P3 filtration pump
P4 Current time
P5 Timer on
P6 Timer off
T1 Inlet water temp.
P7
correction
P8 Debug mode
P9 Compressor frequency
P10 EEV Initial opening
P11 DC fan speed
P12 MODBUS COM
P13 MODBUS ID Address..
7.6.2.1 When there is on one parameter checking, Press
parameter.
7.6.2.2. When there is on parameter checking Current time, Press
to adjust "HOUR" from 0-23. Press
MINUTE from 0 to 59. and press
7.6.2.3. When there is on parameter checking Timer on setting, Press
to adjust "HOUR" from 0-23. Press
or
MINUTE from 0 to 59. and press
7.6.2.4. When there is on parameter checking Timer off setting, Press
to adjust "HOUR" from 0-23. Press
or
" MINUTE" from 0 to 59. and press
7. 7. 7. Start-up Start-up Start-up of of of the the the
to check the parameter from P0-P7.
Range Default
0-1 0
0-2 1
0-1 0
0-1 0
HH:MM 00：00
HH:MM 00：00
HH:MM 00：00
-9～9 0
0-1 0
18-110 50
0-470 350
300-1000 500
0 - 5 0
1 - 88 9
once again to set the MINUTE, press
to save the new setting.
again to set the MINUTE, press
to save the new setting.
again to set the MINUTE, press
to save the new setting.
- 34 -
Heat Heat Heat Pump Pump Pump
Remark
0: defrosting mode;1: mandatory defrosting.
1: heating mode,0: cooling mode, 2:Auto
mode
1:Timer on/off is under function，0:Timer
on/off
is out of function (The setting of P5 and P6
won't work)
1:Always running，
0:Depends on the running of compressor
0-23:0-59
0-23:0-59
0-23:0-59
Default setting: 0
1:P9，P10，P11(could be adjusted)
0: automatic(not adjusted)
Manual adjustment
Manual adjustment
Manual adjustment
Only Modbus function
Only Modbus function
again, and then press
again to set the HOUR, then press
again to set the HOUR, then press
again to set the HOUR, then press
or to setting relative
or
or to adjust the
or to adjust the
or to adjust the