Electrical Protection - Astralpool APH3 INVERBOOST 14 Manuel D'installation Et D'utilisation

6.5 Electrical protection

The power supply for the heat pump must come, preferably, from an exclusive circuit with regulatory
protection components (30mA differential protection) and a magneto-thermal switch.
- The electrical installation must be carried out by a specialized professional (electrician) in
accordance with the standards and regulations in force in the country of installation.
- The heat pump circuit must be connected to a safety earth circuit at the terminal block.
- The cables must be properly installed to prevent interference.
- The pump is intended for connection to a general power supply with earth connection.
- Section of the cable; This section is indicative and should be checked and adapted according to the
needs and conditions of use.
- The tolerance of acceptable voltage variation is +/- 10% during operation.
The connections must be dimensioned according to the power of the device and the state of
installation.
Models
68837
68838
68839
68840
These values are given as a guideline, only an authorized electrician can determine the values
corresponding to your installation. The electric cable must be equipped with a ground connection and
with a circuit breaker with difference 30mA.
6. 6. Electrical Electrical
6. Electrical
Circuit breaker
2,5 mm²
13 A
15 A
18 A
24 A
Wiring Wiring
Wiring
Maximum length of the wire
4 mm²
45 m 75 m
34m 54m
32 m 50 m
/ 35m
- 26 -
6 mm² 10 mm²
110 m 185 m
80 m 135 m
75 m 128m
52 m 95m