Zyxel NWA-3100 Guide De Mise En Route Rapide page 11

10 Change the wireless settings in the wireless stations to match those of the NWA-
3100. Refer to your wireless adapter's documentation.
If you change the NWA-3100's IP address, you must use the new IP
address when you next access the web configurator.
The device is now ready to connect to your wired network. You can do this now, or once
you have installed the hardware.
If the wireless clients cannot access the wired network, verify that the IP
address and the subnet mask of the NWA-3100 and the computers on the
network are in the same range. If the ETHN LED is off, check the cables
between the NWA-3100 and your computer or hub.
4 Install the Hardware
4.1 Attaching Antennas
When facing the front of the NWA-3100, the right antenna (main antenna)
transmits and receives; the left antenna only receives.
1 Screw the antennas clockwise onto the
antenna connectors on the sides of your
NWA-3100. The antennas should be
perpendicular to the ground and parallel
to each other.
Make sure the antennas are securely
screwed onto the antenna connectors.
ENGLISH
10