Bosch TS2000 Consignes De Fonctionnement/Sécurité page 4

Step 1
Attach Upper and Lower Cross Bars
1. Position lower cross bar on a flat surface
as shown in figure A.
2. Insert ends of upper cross bar into the
lower cross bar and push downward as far
as it will go.
3. Insert four (4) 8 mm x 50 mm Phillips Head
Screws through the holes of the upper and
lower cross bars, and securely tighten with
four (4) 8 mm lock nuts as shown.
Step 2
Attach Leg/Wheel Assemblies
1. Locate the right leg/wheel assembly and
position on right side of upper/lower cross
bar assembly as shown in figure B.
2. Place one (1) flat washer onto one (1) 10
mm x 100 mm bolt and insert through right
leg/wheel assembly.
3. Place another (1) 10 mm flat washer on
bolt between leg/wheel assembly and
upper/lower cross bar assembly.
4. Insert bolt through upper/lower cross bar
assembly, place one (1) 10 mm flat
washer, and loosely tighten with one (1) 10
mm lock nut.
Note: Do not over-tighten lock nut - these
parts need to freely rotate for stand to
operate properly.
Repeat procedure on left side.
All manuals and user guides at all-guides.com
Assembly
-4-
FIG. A
FIG. B
Upper
Lock Nut
Cross Bar
Washer Washer
Leg/Wheel
Bolt
Assembly
Washer