Publicité
Les langues disponibles
Les langues disponibles
Read and understand all
!
WARNING
instructions. Failure to
follow all instructions listed below may result
in serious personal injury.
Fully assemble and tighten all the
fasteners required for this stand. Also
remember to occasionally check the
stand and make sure it is still tight. A
loose stand is unstable and may shift in use
and cause serious injury.
Turn tool switch off and disconnect power
before mounting to the stand. Unintended
startup during assembly can cause injury.
You have purchased a Bosch Table Saw
Stand TS2000. Designed for job site use.
This unit sets up and folds quickly, and is
easily loaded or unloaded by one person into
a truck.
For use with the following table saws:
Bosch 4000, Dewalt DW744, Craftsman
21830, and Makita 2703.
TS2000 TABLE SAW STAND
PACKAGE CONTENTS:
Item
Qty.
Part Description
A
(1)
Upper Cross Bar
B
(1)
Lower Cross Bar
C
(1)
Kickback Bar
D
(1)
Right Leg/Wheel Assembly
E
(1)
Left Leg/Wheel Assembly
F
(1)
Table Top
C
All manuals and user guides at all-guides.com
Safety Instructions
Before operating make sure the entire unit
is placed on a solid, flat, level surface.
Serious injury could occur if tool is unstable
and tips.
Never stand on tool or its stand or use as
ladder or scaffolding. Serious injury could
occur if the tool is tipped or the cutting tool is
accidentally contacted. Do not store
materials on or near the tool such that it is
necessary to stand on the tool or its stand to
reach them.
Use only Bosch replacement parts. Any
others may create a hazard.
Pre-Assembly
Phillips screwdriver, 10 MM open end
wrench, 16 MM open end wrench, or
adjustable wrench.
Sort out and account for all parts to make
sure that you have all necessary materials to
assemble your stand. Do not discard packing
material until all parts are accounted for.
E
D
-2-
TOOLS REQUIRED:
BEFORE YOU ASSEMBLE THIS
TABLE SAW STAND:
A
B
F
Publicité
