Publicité
•
To ensure the safe installation and operation of this product the equipment must be installed and
integrated;
o
Using suitably qualified and trained personnel
o
In accordance with any regional electrical codes
o
In accordance with the instructions set out in this manual, observing all information, warnings
and instructions
o
In accordance with any other instructions or guidance FT Technologies provide
•
To ensure that the product remain compliant with the electrical safety requirements of the UL / CSA
61010-1 standards, the equipment must be;
o
Connected to a regionally approved limited PSU rated 12-30VDC (current limited 6A maximum)
o
Protected by UL 1449 Listed surge protective devices
o
Connected with an approved interface cable (for example UL/CSA recognised AWM style 21198,
rated 300V, 80°C)
•
The equipment must only be operated within the range of the specified technical data and used for the
purposes for which it was designed
•
The equipment should always be transported in packaging which is appropriate, that will prevent any
accidental damage from occurring.
•
Always ensure that any failures or errors from the product cannot cause any damage to any other
equipment or property or cause any other consequential effects.
5
FT722 et FT742 (4-20 mA) (4-20 mA) - Capteurs - Manuel de l'utilisateur
Safety Instructions
English
Section 1 - Introduction
Publicité
