Westfalia 85 26 02 Mode D'emploi page 17

 If the disc becomes stuck or locked in the work piece or you
intend to interrupt your work, turn off the electric tool and hold
it tightly until the disc has come to a complete standstill. Never
attempt to lift the spinning disc out of the cut, this may cause
kickback. Verify and remove the cause for the stoppage.
 Do not turn on the electric tool while the disc is in the work
piece. Allow the disc to reach full speed before carefully re-
suming the cut. Otherwise the disc may jam, jump out of the
cut or kick back.
 Support sheets or large work pieces to reduce the risk of a
kickback caused by the disc being wedged in the work piece.
Larger work pieces may deform under their own weight. The
work piece must be supported on both sides, on the edges as
well as close to the cut.
 Be especially careful when undertaking "pocket cuts" in
existing walls or other areas which cannot be overlooked.
When plunging into the wall the disc can kick back when hit-
ting gas or water pipes, wires or other objects in the wall.
 Do not continue using the electric tool if it was damaged or
the tool was dropped or immersed in water. Please contact
our customer support service.
 Only plug the charging station to 230 V mains power. Re-
charge the battery only with the provided charging station.
 Protect the battery and the charging station from humidity. Do
not operate the battery charging station outdoors.
 When not in use and before cleaning and servicing, discon-
nect the charging station from the power supply.
 Take special care of the battery. Avoid dropping it onto any
hard surface and do not subject it to pressure or any other
form of mechanical stress. Keep the battery away from ex-
treme heat and cold.
All manuals and user guides at all-guides.com
Safety Notes
13