Electrolux ESM48400SX Notice D'utilisation page 23

Problem and alarm code
Malfunction of the wash
pump or the drain pump.
The display shows i51 -
i59 or i5A - i5F.
The temperature of the wa‐
ter inside the appliance is
too high or malfunction of
the temperature sensor oc‐
curred.
The display shows i61 or
i69.
Technical malfunction of
the appliance.
The display shows iC0 or
iC3.
The level of water inside
the appliance is too high.
The display shows iF1.
The appliance stops and
starts more times during
operation.
The programme lasts too
long.
The displayed programme
duration is different than
the duration in the con‐
sumption values table.
The remaining time in the
display increases and
skips nearly to the end of
programme time.
Small leak from the appli‐
ance door.
The appliance door is diffi‐
cult to close.
The appliance door opens
during the wash cycle.
Possible cause and solution
• Switch the appliance off and on.
• Make sure that the temperature of the inlet water
does not exceed 60°C.
• Switch the appliance off and on.
• Switch the appliance off and on.
• Switch the appliance off and on.
• Make sure that the filters are clean.
• Make sure that the outlet hose is installed at the right
height above the floor. Refer to the installation in‐
structions.
• It is normal. It provides optimal cleaning results and
energy savings.
• If the delayed start is set, cancel the delay setting or
wait for the end of the countdown.
• The pressure and the temperature of the water, the
variations of the mains supply, the options, the quan‐
tity of dishes and the degree of soil can change the
programme duration.
• This is not a defect. The appliance is working cor‐
rectly.
• The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
• The appliance door is not centred on the tub. Adjust
the rear foot (if applicable).
• The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
• Parts of the tableware are protruding from the bas‐
kets.
• The AirDry function is activated. You can deactivate
the function. Refer to "Settings".
ENGLISH 23