Publicité
Les langues disponibles
Les langues disponibles
Wall Setter Installation
Site Selection for Installation
When choosing a location for the
Multi-zone Controller a conve-
nient and accessible location
should be chosen. The range of
the Controller is approximately 50
feet (15 m).
The Multi-zone Controller
can control multiple Dimplex
ConnEX
heaters outside of the
TM
50 ft (15 m) range by ensuring
that subsequent components in
the system are within 15m (45ft)
of any other component in the
system for the entire system to
operate.
1.
Remove the Multi-zone Con-
troller and installation hard-
ware from its package.
2.
Remove the Insulating strip
as shown in Figure 1.
3.
using the Wall Mounting
Bracket, mark and drill the
holes for the wall anchors.
4.
Install the screws through the
Wall Mounting Bracket and
into the anchors.
! NOTE: Ensure that the flat
side of the Wall Mounting Bracket
is against the wall and the screws
are installed so that they rest
against the extended portion of
All manuals and user guides at all-guides.com
the hole. The space will allow
screws to sit in the mounting
holes correctly.
5.
slide the Wall setter onto the
screws.
Figure 1
Battery strip
Figure 2
screw
Mounting
Holes
Wall anchor
Wall Mounting
Bracket
7
Publicité
