Publicité
Les langues disponibles
Les langues disponibles
general Functions
LPC or the PCH and the controller
will need to be synchronized.
! NOTE: For ease of synchro-
nization it is suggested that the
controller be taken to each heater
to complete the synchronization
process.
1.
Press the
put the controller into syn-
chronization mode.
2.
all four (4) zone icons will
begin to flash.
3.
select the zone that the spe-
cific heater will be associated
with, that icon will become
solid.
4.
Enter the synchronization se-
quence on the desired heater.
5.
When the heaters controller
is in listening mode press the
icon on the controller.
! NOTE: When the synchroniza-
tion is complete the display on
the heater will switch to the new
settings from the controller.
6.
Repeat steps 3-5 until all of
the heaters are synchronized.
7.
Press the
changes and revert back to
operation mode.
5. Lock Function
The controller can be "Locked"
so that the display on the control-
14
All manuals and user guides at all-guides.com
icon, this will
icon to save the
ler are disabled to prevent any
changes to the settings in the
system.
To Enable:
1.
Press the
2.
Enter the sequence Zone 1,
Zone 2, Zone 3 and Zone 4,
then press the
The Controller will display the
Icon and continue to operate
based on the settings and signals
from the controller.
! NOTE: adjustments can
be made to individual heaters
by entering it's specific unlock
sequence and adjusting the set
point.
CAUTION: The adjusted
heater will only retain the new set
point until an event occurs on the
controller and a new set point is
sent.
To Disable:
1.
Press and hold the
3 seconds.
2.
Enter the sequence Zone 1,
Zone 2, Zone 3 and Zone 4,
then press the
Icon.
Icon.
Icon for
Icon.
www.dimplex.com
Publicité
