HumanTechnik Signolux S Mode D'emploi page 13

d) Connect the power supply to the receiv-
er. The time needed for a full charge is
approximately 6 hours.
Display and features
Volume
control
Function button
Signal mode
selector
Melody button
Figure 2: Controls, left side
Setting the signal mode
Using the signal mode slide switch (in fig. 2
"0 1 2") you can select the signal mode.
Kindly keep in mind that the event icons are
always displayed by coloured LEDs.
– switch to position 0:
alert tones, but no flash
– switch to position 1:
alert tones and flash
– switch to position 2:
no alert tones, flash only
Figure 3: Event icons and status LED
Event icon signification
The icons stand for:
Doorbell 1
Doorbell 2
Telephone
Person call
Baby
Fire alarm
Flood alarm
Alarm
Setting the volume
On the left side of the »signolux« receiver
you will find the rotating volume control with
which you can set the volume of the alert
tone.
Warning:
This device can generate sounds of up to
90 dB!
In order to protect your hearing, please set
a low volume to begin with and only then
adjust to the desired volume.
Colour: Green
Colour: Green
Colour: Orange
Colour: Yellow
Colour: White
Colour: Red
Colour: Blue
Colour: Red
English 13