Zodiac Baracuda T5 Duo Mode D'emploi page 13

If you experience a problem with your Baracuda
to restore performance. If further assistance is required, contact Zodiac Customer Service. Please have
your serial number and date of purchase available when you call.
Problem
Cleaner does not move or moves slowly.
Cleaner patterns, does not cover entire pool. • Use Flow Gauge to verify proper flow. Reduce flow to
Cleaner gets stuck at steps.
Cleaner stays on walls or edge of pool.
Cleaner won't climb walls.
All manuals and user guides at all-guides.com
T5 Duo™, please follow the troubleshooting steps below
®
Solution
• Use Flow Gauge to verify proper flow.
• Confirm that the main drain is closed.
• Check diaphragm for blockage, damage or wear.
• Backwash filter and empty pump basket.
• Check for air in system. If water level in pump basket
drops or you see excessive air bubbles in the pump
basket or coming from the return lines, there is air in the
system. Check hose connections, tighten all fittings at
pump and check o-ring at pump basket for wear.
move cleaner off the walls.
• Ensure return fittings are directed down. Add a return
diverter if necessary.
• Make sure hose is not coiled or kinked. Lay in sun
to straighten if necessary.
• Verify correct hose weight positioning: 39 in. (1 m) from
cleaner.
• Verify that the engine assembly spins freely inside the
cleaner body.
• Confirm proper hose length.
• Use Flow Gauge to verify proper flow.
• Confirm proper hose length. Shorten if necessary.
• Use return jets to guide cleaner.
• Using Flow Gauge as guide, reduce flow to number
2 setting.
• Verify correct hose weight positioning: 39 in. (1 m) from
cleaner.
• Use Flow Gauge to verify proper flow, number 3 setting.
• Verify correct hose weight positioning: 39 in. (1 m) from
cleaner.
Troubleshooting
®
ZODIAC is a registered trademark of Zodiac International, S.A.S.U., used under license.
All trademarks referenced herein are the property of their respective owners.
13