Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
7. OPERATING AND SETTING
7.1 Configuration
This converter is composed of a two switches block with two posi-
tions each (Fig. 4 - item S) :
Switch 1
- The SERVICE position is used to enter the parameters of the diffe-
rent modes.
- The OPERATION position allows the selected mode to run and hin-
ders the access to parameters input (normal operating).
Switch 2
- The position "key" is used to lock the touch pad.
- The position "no key" allows to use touch pad.
Example : Locking of set value in mode 1 or 2.
Setting with touch pads :
The selection of a new parameter is done with impulsion on arrows for
touch pads.
« + » on top and « - » on bottom.
A short impulse on the center of touch pads validates this new setting.
7.1.1 Manual mode : MODE 1
When changing the motor speed with the touch pad you reached
the operating point.
Parameters in MODE 1
(If the pump is new and not integrated inside a system, parameters
are already in with operation in Mode 1 ; (see § "Operation in Mode 1").
- Set the switch (Fig. 4 - item S) on position Service.
- Select " M1 ".
- Validate
- Visualisation of the Operating time meter. (number of pump opera-
ting hours)
- Validate
- Set the switch again on position OPERATION.
Operating in Mode 1
For the starting up, we recommend to set the motor speed at 2400
RPM.
By the touch pad the requirement value can be changed.
- Validate the new value.
With a short impulse on the touch pad the actual speed can be dis-
played ; after 30 seconds or a new impulse the requirement value
reappears.
An impulse ~1s allows the ON/OFF function.
- Select OFF.
- Validate.
Note : the remote control (ex : switch) allows a stop of the
pump (variator ON).
When stopping the pump, the sign "OFF" appears.
ON
SERVICE
1
2
ON
1
2
MODE 1 - Mode manuel
29
ON
1
2
ON
1
2
0,1s or 1s
ON
SERVICE
1
2
0,1s
0,1s
ON
OPERATION
1
2
0,1s
1s
0,1s
1s
0,1s
OPERATION
Publicité
