SCS Sentinel OpenGate 1 Manuel D'installation page 24

C- WIRING / INSTALLING C- WIRING / INSTALLING
C1- Wiring diagram
LOCK OR STRIKE : OPTIONAL
C2- Attaching and connecting the elements
• Attach the outdoor station at a height of 1.5 metres mounted on a flat wall back plate.
• The outdoor unit must not be exposed to direct sunlight or the weather. Installation under a porch or a covered
area is highly recommended.
• Remove the top from the panel, slightly lift then slide off the front panel.
• Connect the outdoor station wire and insert the outdoor station on its support.
• Attach the interior unit at a height of 1.5 metres on a flat wall. First fit the rear plastic support, connect the wires
and place the handset on its support.
• Connect the interior unit.
• Perform functional test before finalizing fixing of the elements.
After installing and testing, place a clear silicon seal on the top and sides of the outdoor station (not on the
bottom) to avoid any risk of infiltration.
Outdoor station
4 3
From 0 to 10 metres :
use 1mm² cable.
2 1
From 0 to 50 metres: use 0.75 mm² cable
From 51 to 100 metres : use 1 mm² cable
Back plate outdoor station
187
Connecting cables
not provided
Handset
1
2
3
4
5
6
96
EN
7