Lux Tools E-MH-2500/45 Notice Originale page 31

All manuals and user guides at all-guides.com
Haecksler_401122.book Seite 31 Donnerstag, 7. April 2016 8:40 08
Fault/malfunction
If you are unable to remedy the fault yourself,
please contact your local OBI store. Please
note that the improper performance of repair
work will lead to the loss of any warranty
claims and that additional costs may be
incurred.
Disposal
Disposal of the appliance
Appliances which are labelled with
the adjacent symbol must not be dis-
posed of in household waste. You
must dispose of such old electrical
and electronic equipment separately.
– Please check with your local authority
about the possibilities for correct dis-
posal.
Through separate disposal you send old
equipment for recycling or for other forms of
re-use. You will thus help to avoid in
some cases that damaging material gets into
the environment.
Disposal of the packaging
The packaging consists of card-
board and correspondingly marked
plastics that can be recycled.
– Make these materials available
for recycling.
Technical data
Item number
Rated voltage
Rated output**
Protection class
Degree of protection
Idling speed
Maximum branch diame-
ter
Sound pressure level
(L )*
PA
Sound power level (L
WA
Line impedance Z ***
max
Weight
*) The specified values are emission values and do not necessar-
ily represent safe workplace values. Although there is a corre-
lation between emission and immission levels, this cannot be
used to infer whether additional safety measures are necessary
or not. Factors which affect the current immission levels at the
Cause
Are the blades worn?
401 122
230–240 V~,
50 Hz
2500 W
S6 40% 50 s
II
IP24
-1
4500 min
45 mm
84 dB(A)
(K = 3 dB(A))
)* 106 dB(A)
(K = 2,55 dB(A))
0,351 Ω
13,8 kg
Remedial measure
Replace the blades if neces-
sary.
workplace, include the type of room, other sources of noise,
e. g. the number of machines operating and other processes
taking place in the vicinity. Permitted workplace values can dif-
fer from country to country. This information is designed to help
the user to better assess the dangers and risks.
**) S6 = Continuous operation with periodic duty, duty ratio (DR)
40%, run duration (50 s). For power tools, the observation time
period is 50 seconds. 40% DR means that the powr tool can be
operated at the nominal rated input for 20 seconds, followed by
a cooling down phase of 30 seconds.
***) Special connection conditions according to EN 61000-3-11:
Only connect the device to a power supply with an impedance
less than or equal to Z Contact your electricity supplying
max
company if necessary.
GB
31