Lux Tools E-MH-2500/45 Notice Originale page 30

All manuals and user guides at all-guides.com
Haecksler_401122.book Seite 30 Donnerstag, 7. April 2016 8:40 08
GB
Cleaning and maintenance
DANGER! Risk of injury! Before all
cleaning and maintenance work,
switch the device off and disconnect
the mains plug. Wait until all moving
parts have come to a complete stop
and the device is cooled off.
Cleaning the device
Careful handling and regular cleaning ensure
that the device will remain functional and
powerful for a long time.
– Brush off coarse dirt.
– Wipe down the device with a slightly
damp cloth.
– Never spray the device with water or sub-
ject it to water.
– To clean, never use cleansers or solvents.
This can cause irreparable damage to the
device. The plastic parts can be eaten
away by the chemicals.
Maintenance
Changing the blades
► P. 4, item 5
– Loosen the closure screw (4) and fold out
the hopper.
► P. 4, item 6
– Insert a suitable object (Allen key etc.) as
shown and hold it in the hole (14).
– Loosen the screws (15) with the Allen
key.
– Turn or replace the blade (16).
Fault/malfunction
Motor not running.
Material to be chipped is
not pulled in.
30
Storage and transport
Storage
Transport
Faults and remedial measures
When something isn't working...
Often only small faults cause a malfunction.
You can usually easily remedy such faults
yourself. Please consult the following table
before contacting your local OBI store. This
saves effort and possibly also costs.
Cause
No mains voltage?
Cable faulty?
Was the motor protection triggered? Remove all chipped pieces
Was the safety switch not triggered? Check the connection hopper-
Locking lever in bottom position?
Material blockage?
Are the blades blocked?
– Install in the reverse order.
Note: Blades can also be sharpened.
However, this should be done by a
professional since both blades must
maintain the same weight in order to
maintain the proper balance. An
imbalance of the blades can cause
damage and injuries.
WARNING! Risk of injury! Make
sure that unauthorized persons do
not have access to the device!
• Allow the device and to cool off com-
pletely in storage.
• Store the device in a dry place.
• Secure the device against slipping.
• When shipping, use the original packag-
ing if possible.
DANGER! Risk of injury! Improper
repairs can cause your device to stop
functioning safely. You thus endan-
ger yourself and your environment.
Remedial measure
Check cable, plug, socket and
fuse.
Contact your local OBI store.
and press reset button.
motor housing.
Change locking lever to top
position.
Remove all chipped pieces
from the blades.
Remove all chipped pieces
and press reset button.