Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Haecksler_401122.book Seite 28 Donnerstag, 7. April 2016 8:40 08
GB
• Do not attempt to remove materials to be
chipped or to hold already chipped mate-
rial when the blades are running. Only
remove any jammed material to be
chipped when the device is switched off.
• Avoid direct contact with the rotating cut-
ting blade. Keep your hands and feet out-
side of the openings when the machine is
running.
• Do not put your hands, other body parts
or clothing in the filling chamber, ejection
channel or near other moving parts.
• Always remove the chipped material from
the ejection zone before it piles up. This
way, you avoid having the chipper get
stopped up and having the chipped
material go back into the hopper on
rebound and thus cause accidents.
• No other persons or animals may be pre-
sent within an area of 3 m around the
work area, as they may otherwise by hit
by objects being slung away.
• Do not operate the device on plastered or
concrete surfaces. The chipped material
can rebound and cause injuries.
• Remember that moving parts may also
be located behind ventilation and venting
slots.
• Symbols appearing on your product may
not be removed or covered. Information
on the product that are no longer legible
must be replaced immediately.
Observe the safety instructions be-
fore using the product for the first
time.
Read and observe the instructions
for use before using the product for
the first time.
Risk of slicing.
Do not reach into the hopper.
Danger due to foreign bodies being
thrown out.
Maintain a safe distance from per-
sons standing around.
Remove the plug from the mains im-
mediately if the cable is damaged or
cut.
28
Personal protective equipment
When working with the product,
wear hearing protection and safety
goggles.
Wear sturdy shoes when working
with the product.
Wear protective gloves when work-
ing with the product.
Wear tight-fitting clothing when
working with the product.
Your product at a glance
► P. 3, item 1
1. Hopper
2. Reset button
3. Handle
4. Locking screw
5. On-Off switch
6. Mains plug
7. Locking lever
8. Collection tray
Supplied as standard
• Instructions for use
• Shredder
• Collection tray
• Prodder
• Frame
• Axle
• Wheels
• Wheel caps
• screws and washers
Note: If a part is missing or dam-
aged, please contact the vendor.
Assembly
Mounting the frame
► P. 3, item 2
– Screw down the frame (9) to the device
as illustrated with the screws (10).
Mounting the wheels
► P. 3, item 2
– Push the axle (11) into the frame.
– Push the washer and socket (12) onto the
axle.
– Push the wheel onto the axle.
– Tighten the wheel with the washer and
nut (13).
– Place the wheel cap on the wheel.
Publicité
