Shure Microflex MX100 Serie Mode D'emploi page 2

MX100
Lavalier Microphones
Shure Microflex MX100 Series microphones are
®
wired lavalier electret condenser microphones
designed for speech and vocal pickup, general
purpose sound reinforcement, recording, and re-
mote monitoring applications. They can be clipped
to neckties, lapels, and other articles of clothing.
Interchangeable cartridges make it possible to
easily reconfigure microphone coverage as the
need arises.
• Wide dynamic range and frequency response
for accurate sound reproduction
• Interchangeable cartridges that provide a
choice of polar pattern for each application
• Rotatable tie-clip that pivots in 90° increments
for placement flexibility
• Dual tie-clip and belt-clip preamp
• Supplied with snap-fit foam windscreen that
controls breath noise
• Balanced, transformerless output for increased
immunity to noise over long cable runs
• RF filtering
2
All manuals and user guides at all-guides.com
Interchangeable Cartridges
Microflex microphones
use interchangeable car-
tridges that allow you to
choose the polar pattern
for different installations.
R183 Omnidirectional
R184 Supercardioid
R185 Cardioid
Windscreen
Foam Screen
Slip the windscreen over the top of microphone
so it covers side slots. The foam windscreen pro-
vides 5 to 10 dB of "pop" protection.
Snap-Fit Windscreen
• Snap into the groove
below the cartridge.
• To remove, spread the
gap with a screwdriver
or thumbnail.
• Provides 30 dB of "pop"
protection.
Preamp Gain
If necessary, the preamplifier gain
can be reduced by 12 dB. Contact
an authorized Shure service center
for information.
R6 and R4
C10
Q2
Q8
Q3
Q9
Q7 Q6
C11 C11
R13 and R16
RFI Filtering
Important: Microphones must be used with the
RK100PK preamp to optimize RF immunity.
Q1
Q5