Publicité
Les langues disponibles
Les langues disponibles
BM 2610925942 6-05
6/9/05
Strike long arm of wrench sharply
counterclockwise, remove wrench and
unthread chuck from spindle.
INSTALLING CHUCK
Always keep the spindle threads, the threads
of the chuck and securing screw free of
debris. To install a chuck, reverse "removing
the chuck" procedure.
Release battery pack from tool by pressing
on both sides of the battery release tabs and
pull downwards. Before inserting battery
pack, remove protective cap from battery
1.
The battery pack accepts only
about 80% of its maximum capacity with its
first few charge cycles. However, after the
first few charge cycles, the battery will
charge to full capacity.
2. The charger was designed to fast charge
the battery only when the battery
temperature is between 40˚F (4˚C) and
105˚F (41˚C).
3. A substantial drop in operating time per
charge may mean that the battery pack is
nearing the end of its life and should be
replaced.
4. If you anticipate long periods (i.e. a month
or more) of non-use of your tool, it is best to
run your tool down until it is fully discharged
before storing your battery pack. After a long
period of storage, the capacity at first recharge
will be lower. Normal capacity will be restored
in two or three charge/discharge cycles.
3:24 PM
Page 10
All manuals and user guides at all-guides.com
RELEASING AND INSERTING BATTERY PACK
IMPORTANT CHARGING NOTES
Remember to unplug charger during storage
period.
5. If battery does not charge properly:
in some other electrical device.
light switch which turns power "off" when
lights are turned off.
Clean with cotton swab and alcohol if
necessary.
take or send tool, battery pack and charger
to your local Bosch Service Center. See
"Tools, Electric" in the Yellow Pages for
names and addresses.
Note: Use of chargers or battery packs not
sold by Bosch will void the warranty.
-10-
FIG. 3
pack. To insert battery, align battery and slide
battery pack into tool until it locks into
position. Do not force.
a. Check for voltage at outlet by plugging
b. Check to see if outlet is connected to a
c. Check battery pack terminals for dirt.
d. If you still do not get proper charging,
Publicité
