Homelite EL12 Manuel De L'utilisateur page 8

HOMELITE EL12 AND EL16
ELECTRIC CHAINSAW
OPERATING CHAIN
SAW
WARNING: Read and under-
stand this owner's manual be-
fore operating this saw. Make
certain you read and understand
all Safety Warnings. Improper use
of this chain saw can cause se-
vere injury or death from fire,
electrical shock, or body contact
with moving chain, or falling
wood.
EXTENSION CORDS
Use proper extension cords with this saw.
Use only extension cords marked for out-
door use. The cord must be marked with
suffix W-A following the cord type designa-
tion. Example: SJTW-A, or SJTW
Use proper sized cord with this saw. Cord
must be heavy enough to carry current
needed. An undersized cord will cause volt-
age drop at saw. Saw will lose power and
overheat. Follow cord size requirements
listed below.
Cord Length SWG Cord Size
25 feet
50 feet
100 feet
150 feet
Keep cord away from cutting area. Make
sure cord does not catch on branches or logs
during cutting. Inspect cords often. Replace
damaged cords.
The extension cord may come undone from
the power cord during use. To avoid this,
make a knot with the two cords as shown in
Figure 7 below.
Extension Cord
Figure 7 - Tying Extension Cord and
Power Cord in Knot
All manuals and user guides at all-guides.com
OILING CHAIN
Always check oil level before using saw. To
oil chain, press oil cap. Oil will feed onto
guide bar and chain. Press oil cap at least
once before each cut. Check oil level often
by looking at oil level sight hole. Oil level
sight hole is on left side of saw, between
front handle and front hand guard.
Figure 8 - Pressing Oil Cap to Oil Chain
CUTTING WITH THE CHAIN
SAW
1. Connect saw to extension cord. Con-
nect extension cord to power supply.
2. Make sure section of log to be cut is
not laying on ground. This will keep
chain from touching ground as it cuts
16
through log. Touching ground with
16
moving chain will dull chain.
14
3. Use both hands to grip saw. Always use
12
left hand to grip front handle and right
hand to grip rear handle. Use firm grip.
Thumbs and fingers must wrap around
saw handles (see Figure 9).
4. Make sure your footing is firm. Keep
feet apart. Divide your weight evenly
on both feet.
Chain Saw
Power Cord
Figure 9 - Switch Lockout and Trigger Location
5. When ready to make a cut, press in
6. When starting a cut, place moving
7. Guide saw using light pressure. Do not
8. Remove saw from a cut with saw run-
9. Practice until you can maintain a steady,
8
switch lockout with right thumb and
squeeze trigger (see Figure 9). This will
turn saw on. Releasing trigger will turn
saw off. Make sure saw is running at
full speed before starting a cut.
chain against wood. Hold saw firmly
in place to avoid possible bouncing or
skating (sideways movement) of saw.
force saw. The motor will overload and
can burn out.
ning at full speed. Stop saw by releas-
ing trigger. Make sure chain has
stopped before setting saw down.
even cutting rate.
Switch
Lockout
Trigger
100803