Publicité
Les langues disponibles
Les langues disponibles
9. INSTALL THE TRANSITION
Attach the provided transition to top of hood. Use metal duct tape to make all
joints secure and air tight.
10. INSTALL THE DECORATIVE FLUE (OPTIONAL)
O
D
PTIONAL
ECORATIVE
Refer to the instructions included with the optional decorative flue.
If this decorative flue is installed in a salt water area (example: coast), rinse all surfaces once a week with
clear water (even if the hood is not used), and wipe dry completely.
11. INSTALL THE HOOD
Rest the top back cavity of the hood on the wood mounting strip.
Hold the hood until it is completely secured to the wood
mounting strip.
Attach transition to 10" round duct. Secure the hood to wood mounting strip with
(5) screws provided at locations shown. Drill (2) 3/16'' size holes into the drywall
for wall anchors through the existing holes in the inside hood back in the
locations shown. Then, install the two wall anchors with the remaining #8 x 3/4"
screws and the (2) washers provided.
12. INSTALL THE BLOWER
Assemble barrel nut (packed with blower) approximately halfway onto threaded
stud on top inside of hood.
Lift blower to top inside of hood. Slide blower back to engage blower tab with slot
in hood top and slot in blower with barrel nut.
Use a long, flat-bladed screwdriver to tighten the barrel nut securely. Plug motor
into receptacle, on exterior side of wire box.
All manuals and user guides at all-guides.com
F
AEWPD S
LUE
ERIES
CAUTION
(INTERIOR BLOWER ONLY)
HD0057
CAUTION
HD0184
HD0061
HD0054
- 8 -
T
(
OP OF HOOD
INSIDE VIEW
M
OUNTING SCREWS LOCATION
B
(
ACK OF HOOD
INSIDE VIEW
W
ALL ANCHORS LOCATION
S
OF HOOD
B
ARREL NUT ON
THREADED STUD
D
D
ISCHARGE
ISCHARGE
OPENING
OPENING
B
LOWER MOTOR
F
-
LAT
BLADED
SCREWDRIVER
)
)
LOT IN TOP
B
ARREL NUT
Publicité
