BaByliss PRO Orchid BAB6150ORCE Mode D'emploi page 5

Concentrator nozzles
The 2 concentrator nozzles have
an opening of 7 mm allowing for
very precise drying and styling.
The 78-mm concentrator nozzle
is designed for drying short hair
and the 94-mm nozzle is perfectly
suited for medium-length and
long hair.
OPERATION
• Plug the hairdryer in.
• Choose the speed by pressing
the switch located on the handle
into the desired position:
- speed setting I by pressing to
the left.
- speed setting II by pressing to
the right.
• The temperature will be dis-
played on the digital screen. The
temperature control wheel lets
you reduce or increase the dry-
ing temperature:
- reduce the temperature by turn-
ing the wheel toward the left.
- increase the temperature by
turning the wheel to the right.
• The cool air button located on
the inside of the handle lets you
set a curl or the whole hairstyle
for a long-lasting effect and give
brilliance to the hair. Its use will
also be displayed on the screen.
• After using the hairdryer, turn off
and unplug the appliance. Let it
cool before storing.
Important
This hairdryer has a safety thermo-
stat. If it overheats, it will stop au-
tomatically. After a short period, it
will start again.
CLEANING AND MAINTENANCE
The BAB6150ORCE hairdryer has
a removable rear filter to prevent
hair or dust from entering the ap-
pliance's motor. To maintain the
efficiency of the hairdryer, regu-
larly clean the filter of the appli-
ance with a soft and dry brush. To
remove the filter:
• Make sure the appliance is turned
off, unplugged and cool.
• Remove the filter by sliding it off
the body of the hair dryer.
• Turn the filter 90° over the hair
dryer and release the 2 hooks
from the notches.
• Use the soft brush to remove hair
and dust.
• To replace the filter, place the
two hooks into the notches while
holding the filter perpendicular
to the appliance.
• Turn the filter 90° and slide it back
into its original position.
5