Publicité
Troubleshooting
Problem
commeo Sensor WS/WSRF does not
function
Motor does not function, transmis-
sion control light flashes
Awning does not extend when the
sun is shining
Awning remains extended even if
there is no sunshine
Awning retracts if there is a slight
breeze
Awning does not retract at heavy
winds
All manuals and user guides at all-guides.com
Cause
Electric connection defective
Receiver/motor outside the radio
range
Transmitter is not programmed into
the receiver/motor
Sun threshold value set too high
The system is set to manual mode
Sensor positioned in the shade
The system is in wind alarm
Sun threshold value set too low
Wind threshold value set too low
Sensor is positioned in the lee
Wind value is set too high
Solution
Check the connection
Reduce distance
Programme transmitter
Lower the sun threshold value
Set sliding switch MAN/AUTO to
AUTO
Change the position of the sensor
Wait until the wind abates
Have the wind threshold value reset
by a specialist
Set the sun threshold value higher
Have the wind threshold value reset
by a specialist
Change the position of the sensor
Have the wind threshold value reset
by a specialist
Publicité
