Oregon PH600 Mode D'emploi page 18

All manuals and user guides at all-guides.com
Troubleshooting
Use this table to see possible solutions for problems with the brush cutter If these suggestions do not
solve the problem, see "Warranty and Service"
SYMPTOM
Motor does
not run or runs
intermittently
Battery pack does
not charge
18
Troubleshooting
POSSIBLE CAUSE
Battery discharged
Trigger-lock lever not
pressed
Battery pack not fully
inserted
Battery contacts dirty
Battery pack too hot or
too cold
Electronics cooling vent
clogged
There is a short delay in
the motor starting after
engaging the trigger-lock
lever
Internal wiring of garden
product damaged
Motor protector has
activated
Battery pack over/under
temperature protection
is activated
Dirty or damaged
contacts on battery pack
or charger
Battery pack is at the
end of its life
Charger faulty
RECOMMENDED ACTIONS
Recharge See "Battery Pack and Charger"
Press the trigger-lock lever before squeezing the
trigger switch See "General Operation"
Press the battery pack into the battery port until it
clicks into place
Remove the battery pack, remove debris from the
battery port, and then clean the contacts with a clean,
dry cloth
Allow the battery pack to warm or cool to within the
operating temperature range of 32°F to 104°F (0°C
to 40°C)
Clear any debris from the vent to provide
unobstructed airflow to the variable speed trigger
Hold the trigger-lock lever for 1 – 3 seconds before
engaging variable speed trigger to start motor
Contact service agent
Allow motor to cool and increase height of cut
This may occur when the powerhead is run
continuously or exposed to high ambient
temperatures Allow the battery pack to reach
the acceptable temperature before charging See
"Battery Pack and Charger"
Inspect the contacts on both the battery pack
and charger If necessary, clean according to the
instructions in this manual Reinsert battery pack into
the charger, making sure it is fully seated
All batteries have a finite life If the battery pack
is more than two years old or has been recharged
frequently, it may be time to replace it Replace only
with the battery pack specified for this powerhead
Have the function checked at an approved service
location
Multi-attachment Powerhead