MSI 661FM3-V Serie Mode D'emploi page 12

All manuals and user guides at all-guides.com
Fan Power Connectors: CPUFAN1/CHSFAN1
The CPUFAN1 (processor fan) and CHSFAN1 (system fan)
SENSOR
CONTROL
support system cooling fan with +12V. They support
SENSOR
+12V
+12V
GND
three-pin/four-pin head connector. When connecting the wire
GND
CPUFAN1 CHSFAN1
to the connectors, always take note that the red wire is the
positive and should be connected to the +12V, the black wire
is Ground and should be connected to GND.
MSI Reminds You...
Always consult the vendors for proper CPU cooling fan.
IDE Connectors: IDE1 & IDE2
The mainboard has a 32-bit Enhanced PCI IDE and Ultra DMA 33/66/100/133
controller that provides PIO mode 0~4, Bus Master, and Ultra DMA 33/66/100/133
function. You can connect up to four hard disk drives, CD-ROM, 120MB Floppy and
other devices.
The first hard drive should always be connected to IDE1. IDE1 can connect a Master
and a Slave drive. You must configure second hard drive to Slave mode by setting
the jumper accordingly. IDE2 can also connect a Master and a Slave drive.
MSI Reminds You...
If you install two hard disks on cable, you must configure the second drive to Slave mode by
setting its jumper. Refer to the hard disk documentation supplied by hard disk vendors for jumper
setting instructions.
8